| == Configuring OsmoSGSN |
| |
| Contrary to other network elements (like OsmoBSC, OsmoNITB), the |
| OsmoSGSN has a relatively simple configuration. |
| |
| On the one hand, this is primary because the PCU configuration happens |
| from the BSC side. |
| |
| On the other hand, it is because the Gb interface does not need an |
| explicit configuration of all each PCU connecting to the SGSN. The |
| administrator only has to ensure that the NS and BSSGP layer identities |
| (NSEI, NSVCI, BVCI) are unique for each PCU connecting to the SGSN. |
| |
| === Configuring the Gp interface |
| |
| The Gp interface is the GTP-C and GTP-U based interface between the SGSN |
| and the GGSNs. It is implemented via UDP on well-known source and |
| destination ports. |
| |
| When a MS requests establishment of a PDP context, it specifies the APN |
| (Access Point Name) to which the context shall be established. This APN |
| determines which GGSN shall be used, and that in turn determines which |
| external IP network the MS will be connected to. |
| |
| There are two modes in which GGSNs can be configured: |
| |
| . static GGSN/APN configuration |
| . dynamic GGSN/APN configuration |
| |
| ==== Static GGSN/APN configuration |
| |
| In this mode, there is a static list of GGSNs and APNs configured in |
| OsmoSGSN via the VTY / config file. |
| |
| This is a non-standard method outside of the 3GPP specifications for the |
| SGSN, and is typically only used in private/small GPRS networks without |
| any access to a GRX. |
| |
| .Example: Static GGSN/APN configuration (single catch-all GGSN) |
| ---- |
| OsmoSGSN(config-sgsn)# gtp local-ip 172.0.0.1 <1> |
| OsmoSGSN(config-sgsn)# ggsn 0 remote-ip 127.0.0.2 <2> |
| OsmoSGSN(config-sgsn)# ggsn 0 gtp-version 1 <3> |
| OsmoSGSN(config-sgsn)# apn * ggsn 0 <4> |
| ---- |
| <1> Configure the local IP address at the SGSN used for Gp/GTP |
| <2> Specify the remote IP address of the GGSN (for GGSN 0) |
| <3> Specify the GTP protocol version used for GGSN 0 |
| <4> Route all APN names to GGSN 0 |
| |
| |
| ==== Dynamic GGSN/APN configuration |
| |
| In this mode, the SGSN will use a DNS-based method to perform the lookup |
| from the APN (as specified by the MS) towards the GGSN IP address. |
| |
| This is the official method as per the 3GPP specifications for the SGSN, |
| and what is used on GRX. |
| |
| .Example: Dynamic GGSN/APN configuration |
| ---- |
| OsmoSGSN(config-sgsn)# gtp local-ip 192.168.0.11 <1> |
| OsmoSGSN(config-sgsn)# ggsn dynamic <2> |
| OsmoSGSN(config-sgsn)# grx-dns-add 1.2.3.4 <3> |
| ---- |
| <1> Configure the local IP address at the SGSN used for Gp/GTP |
| <2> Enable the dynamic GGSN resolving mode |
| <3> Specify the IP address of a DNS server for APN resolution |
| |
| |
| === Subscriber Configuration |
| |
| As opposed to OsmoNITB, OsmoSGSN does not feature a built-in HLR. |
| |
| It can thus operate only in the following two modes: |
| |
| . Accessing an external HLR (or HLR gateway) via the GSUP protocol |
| . Accepting subscribers based on internal ACL (access control list) |
| |
| ==== Accessing an external HLR via GSUP |
| |
| The non-standard GSUP protocol was created to provide OsmoSGSN with |
| access to an external HLR while avoiding the complexities of the |
| TCAP/MAP protocol stack commonly used by HLRs. |
| |
| A custom HLR could either directly implement GSUP, or an external gateway |
| can be used to convert GSUP to the respective MAP operations. |
| |
| The primitives/operations of GSUP are modelled to have a 1:1 |
| correspondence to their MAP counterparts. However, the encoding is much |
| simplified by use of a binary TLV encoding similar to Layer 3 of |
| GSM/GPRS. |
| |
| GSUP performs a challenge-response authentication protocol called OAP, |
| which uses the standard MILEAGE algorithm for mutual authentication |
| between OsmoSGSN and the HLR/HLR-GW. |
| |
| [[sgsn-ex-gsup]] |
| .Example: Using an external HLR via GSUP |
| ---- |
| OsmoSGSN(config-sgsn)# gsup remote-ip 2.3.4.5 <1> |
| OsmoSGSN(config-sgsn)# gsup remote-port 10000 <2> |
| OsmoSGSN(config-sgsn)# gsup oap-k 000102030405060708090a0b0c0d0e0f <3> |
| OsmoSGSN(config-sgsn)# gsup oap-opc 101112131415161718191a1b1c1d1e1f <4> |
| ---- |
| <1> Configure the IP address of the (remote) HLR or HLR-GW |
| <2> Configure the TCP port of the (remote) HLR or HLR-GW |
| <3> Specify the OAP shared key |
| <4> Specify the OAP shared OPC |
| |
| |
| === CDR configuration |
| |
| OsmoSGSN can write a text log file containing CDR (call data records), |
| which are commonly used for accounting/billing purpose. |
| |
| .Example: CDR configuration |
| ---- |
| OsmoSGSN(config-sgsn)# cdr filename /var/log/osmosgsn.cdr |
| OsmoSGSN(config-sgsn)# cdr interval 600 <1> |
| ---- |
| <1> Periodically log existing PDP contexts every 600 seconds (10 min) |
| |
| The CDR file is a simple CSV file including a header line naming the |
| individual fields of each CSV line. |
| |
| [[sgsn-cdr]] |
| .Descripton of CSV fields in OsmoSGSN CDR file |
| [options="header",cols="15%,85%"] |
| |=== |
| |Field Name|Description |
| |timestamp|Timestamp in YYYYMMDDhhmmssXXX where XXX are milli-seconds |
| |imsi|IMSI causing this CDR |
| |imei|IMEI causing this CDR |
| |msisdn|MSISDN causing this CDR (if known) |
| |cell_id|Cell ID in which the MS was registered last |
| |lac|Location Area Code in which the MS was registered last |
| |hlr|HLR of the subscriber |
| |event|Possible events are explained below in <<sgsn-cdr-event>> |
| |pdp| |
| |pdp_duration|duration of the PDP context so far |
| |ggsn_addr|GGSN related to the PDP context |
| |sgsn_addr|SGSN related to the PDP context |
| |apni|APN identifier of the PDP context |
| |eua_addr|IP address allocated to the PDP context |
| |vol_in|Number of bytes in MO direction |
| |vol_out|Number of bytes in MT direction |
| |charging_id|Related charging ID |
| |=== |
| |
| [[sgsn-cdr-event]] |
| .Description of OsmoSGSN CDR Events |
| [options="header",cols="15%,85%"] |
| |=== |
| |Event|Description |
| |attach|GMM ATTACH COMPLETE about to be sent to MS |
| |update|GMM ROUTING AREA UPDATE COMPLETE about to be sent to MS |
| |detach|GMM DETACH REQUEST received from MS |
| |free|Release of the MM context memory |
| |pdp-act|GTP CREATE PDP CONTEXT CONFIRM received from GGSN |
| |pdp-deact|GTP DELETE PDP CONTEXT CONFIRM received from GGSN |
| |pdp-terminate|Forced PDP context termination during MM context release |
| |pdp-free|Release of the PDP context memory |
| |=== |