| /* |
| * gpsdo.c |
| * |
| * Copyright (C) 2019-2022 Sylvain Munaut <tnt@246tNt.com> |
| * SPDX-License-Identifier: GPL-3.0-or-later |
| */ |
| |
| #include <stdint.h> |
| #include <string.h> |
| |
| #include "console.h" |
| #include "gps.h" |
| #include "gpsdo.h" |
| #include "misc.h" |
| |
| #include "ice1usb_proto.h" |
| |
| |
| struct { |
| /* Current tuning */ |
| struct { |
| uint16_t coarse; |
| uint16_t fine; |
| } tune; |
| |
| /* Measurements */ |
| struct { |
| uint32_t tick_prev; /* Previous tick value */ |
| uint32_t last; /* Last measurement */ |
| int skip; /* Number of measurement left to discard */ |
| int invalid; /* Number of consecutive invalid measurements */ |
| } meas; |
| |
| /* FSM */ |
| enum { |
| STATE_DISABLED, /* Forced to manual */ |
| STATE_HOLD_OVER, /* GPS invalid data, hold */ |
| STATE_TUNE_COARSE, /* Adjust coarse tuning until we're +- 3 Hz */ |
| STATE_TUNE_FINE, /* Fine tracking */ |
| } state; |
| |
| /* Coarse tuning */ |
| struct { |
| int vctxo_sensitivity; |
| int step; |
| } coarse; |
| |
| /* Fine tracking */ |
| struct { |
| int acc; |
| int div; |
| } fine; |
| |
| } g_gpsdo; |
| |
| |
| /* VCXTO sensitivity vs 'coarse' count for fast initial acquisition */ |
| /* |
| * Note that the spec if often a guaranteed minimum range and goes |
| * from ~0.1V to 3.2V instead of 0-3.3V so actual sensitivity is |
| * higher than the "theoritical value". We boost it by ~ 10% here. |
| */ |
| static const int |
| vctxo_sensitivity[] = { |
| /* +- 50 ppm pull range => ~ 0.75 Hz / hi-count (set to 0.85) */ |
| [VCTXO_TAITIEN_VT40] = 300, |
| |
| /* +- 100 ppm pull range => ~ 1.50 Hz / hi-count (set to 1.6) */ |
| [VCTXO_SITIME_SIT3808_E] = 160, |
| }; |
| |
| /* Tuning params */ |
| #define TARGET 30720000 |
| #define MAX_DEV_VALID 1000 |
| #define MAX_DEV_FINE 3 |
| #define MAX_INVALID 5 |
| |
| |
| static void _gpsdo_coarse_start(void); |
| |
| |
| void |
| gpsdo_get_status(struct e1usb_gpsdo_status *status) |
| { |
| const uint8_t state_map[] = { |
| [STATE_DISABLED] = ICE1USB_GPSDO_STATE_DISABLED, |
| [STATE_HOLD_OVER] = ICE1USB_GPSDO_STATE_HOLD_OVER, |
| [STATE_TUNE_COARSE] = ICE1USB_GPSDO_STATE_TUNE_COARSE, |
| [STATE_TUNE_FINE] = ICE1USB_GPSDO_STATE_TUNE_FINE, |
| }; |
| const uint8_t ant_map[] = { |
| [ANT_UNKNOWN] = ICE1USB_GPSDO_ANT_UNKNOWN, |
| [ANT_OK] = ICE1USB_GPSDO_ANT_OK, |
| [ANT_OPEN] = ICE1USB_GPSDO_ANT_OPEN, |
| [ANT_SHORT] = ICE1USB_GPSDO_ANT_SHORT, |
| }; |
| |
| status->state = state_map[g_gpsdo.state]; |
| status->antenna_status = ant_map[gps_antenna_status()]; |
| status->valid_fix = gps_has_valid_fix(); |
| status->mode = (g_gpsdo.state == STATE_DISABLED) ? ICE1USB_GPSDO_MODE_DISABLED : ICE1USB_GPSDO_MODE_AUTO; |
| status->tune.coarse = g_gpsdo.tune.coarse; |
| status->tune.fine = g_gpsdo.tune.fine; |
| status->freq_est = g_gpsdo.meas.last; |
| } |
| |
| void |
| gpsdo_enable(bool enable) |
| { |
| if (!enable) |
| g_gpsdo.state = STATE_DISABLED; |
| else if (g_gpsdo.state == STATE_DISABLED) |
| g_gpsdo.state = STATE_HOLD_OVER; |
| } |
| |
| bool |
| gpsdo_enabled(void) |
| { |
| return g_gpsdo.state != STATE_DISABLED; |
| } |
| |
| void |
| gpsdo_set_tune(uint16_t coarse, uint16_t fine) |
| { |
| /* Set value */ |
| g_gpsdo.tune.coarse = coarse; |
| g_gpsdo.tune.fine = fine; |
| |
| pdm_set(PDM_CLK_HI, true, g_gpsdo.tune.coarse, false); |
| pdm_set(PDM_CLK_LO, true, g_gpsdo.tune.fine, false); |
| |
| /* If we were in 'fine' mode, reset to coarse */ |
| if (g_gpsdo.state == STATE_TUNE_FINE) |
| _gpsdo_coarse_start(); |
| } |
| |
| void |
| gpsdo_get_tune(uint16_t *coarse, uint16_t *fine) |
| { |
| *coarse = g_gpsdo.tune.coarse; |
| *fine = g_gpsdo.tune.fine; |
| } |
| |
| |
| static void |
| _gpsdo_coarse_start(void) |
| { |
| /* Set the state */ |
| g_gpsdo.state = STATE_TUNE_COARSE; |
| |
| /* Skip a few measurements to be safe */ |
| g_gpsdo.meas.skip = 3; |
| |
| /* Reset coarse tuning state */ |
| g_gpsdo.coarse.step = 0; |
| |
| /* Put the fine adjust back in the middle point */ |
| g_gpsdo.tune.coarse += ((int)g_gpsdo.tune.fine - 2048) >> 6; |
| g_gpsdo.tune.fine = 2048; |
| |
| pdm_set(PDM_CLK_HI, true, g_gpsdo.tune.coarse, false); |
| pdm_set(PDM_CLK_LO, true, g_gpsdo.tune.fine, false); |
| } |
| |
| static void |
| _gpsdo_fine_start(void) |
| { |
| /* Set the state */ |
| g_gpsdo.state = STATE_TUNE_FINE; |
| |
| /* Reset the long term error tracking */ |
| g_gpsdo.fine.acc = 0; |
| g_gpsdo.fine.div = 0; |
| } |
| |
| static void |
| _gpsdo_coarse_tune(uint32_t tick_diff) |
| { |
| int freq_diff = (int)tick_diff - TARGET; |
| |
| /* Is the measurement good enough to switch to fine ? */ |
| if ((freq_diff > -MAX_DEV_FINE) && (freq_diff < MAX_DEV_FINE)) { |
| _gpsdo_fine_start(); |
| return; |
| } |
| |
| /* Estimate correction and apply it */ |
| g_gpsdo.tune.coarse -= (freq_diff * g_gpsdo.coarse.vctxo_sensitivity) >> 8; |
| pdm_set(PDM_CLK_HI, true, g_gpsdo.tune.coarse, false); |
| |
| /* Skip next measurement */ |
| g_gpsdo.meas.skip = 1; |
| |
| /* Debug */ |
| #ifdef GPSDO_DEBUG |
| printf("[+] GPSDO Coarse: err=%d tune=%d\n", freq_diff, g_gpsdo.tune.coarse); |
| #endif |
| } |
| |
| static void |
| _gpsdo_fine_track(uint32_t tick_diff) |
| { |
| int freq_diff = (int)tick_diff - TARGET; |
| uint16_t tune; |
| |
| /* Did we deviate too much ? */ |
| if ((freq_diff < -2*MAX_DEV_FINE) && (freq_diff > 2*MAX_DEV_FINE)) { |
| _gpsdo_coarse_start(); |
| return; |
| } |
| |
| /* Accumulate long term error */ |
| g_gpsdo.fine.acc += freq_diff; |
| |
| /* Update fine tuning value */ |
| if (((g_gpsdo.fine.acc >= 0) && (freq_diff > 0)) || |
| ((g_gpsdo.fine.acc <= 0) && (freq_diff < 0))) |
| { |
| g_gpsdo.tune.fine -= freq_diff; |
| } |
| |
| if (g_gpsdo.fine.acc) { |
| if (++g_gpsdo.fine.div > 10) { |
| g_gpsdo.fine.div = 0; |
| if (g_gpsdo.fine.acc > 0) |
| g_gpsdo.tune.fine--; |
| else if (g_gpsdo.fine.acc < 0) |
| g_gpsdo.tune.fine++; |
| } |
| } else { |
| g_gpsdo.fine.div = 0; |
| } |
| |
| /* Apply value with a bias from long term accumulator */ |
| tune = g_gpsdo.tune.fine - (g_gpsdo.fine.acc / 2); |
| pdm_set(PDM_CLK_LO, true, tune, false); |
| |
| /* Debug */ |
| #ifdef GPSDO_DEBUG |
| printf("[+] GPSDO Fine: err=%d acc=%d tune=%d\n", freq_diff, g_gpsdo.fine.acc, g_gpsdo.tune.fine); |
| #endif |
| } |
| |
| |
| void |
| gpsdo_poll(void) |
| { |
| uint32_t tick_now, tick_diff; |
| bool valid; |
| |
| /* Get current tick and check if there was a PPS and estimate frequency */ |
| tick_now = time_pps_read(); |
| |
| if (tick_now == g_gpsdo.meas.tick_prev) |
| return; |
| |
| g_gpsdo.meas.last = tick_diff = tick_now - g_gpsdo.meas.tick_prev; |
| g_gpsdo.meas.tick_prev = tick_now; |
| |
| /* If we're currently discarding samples, skip it */ |
| if (g_gpsdo.meas.skip) { |
| g_gpsdo.meas.skip--; |
| return; |
| } |
| |
| /* If we're disabled, nothing else to do */ |
| if (g_gpsdo.state == STATE_DISABLED) |
| return; |
| |
| /* Check GPS state */ |
| if (!gps_has_valid_fix()) { |
| /* No GPS fix, go to hold-over */ |
| g_gpsdo.state = STATE_HOLD_OVER; |
| return; |
| } |
| |
| /* Check measurement plausibility */ |
| valid = (tick_diff > (TARGET - MAX_DEV_VALID)) && (tick_diff < (TARGET + MAX_DEV_VALID)); |
| |
| if (valid) { |
| /* If we're in hold-over, switch to active */ |
| if (g_gpsdo.state == STATE_HOLD_OVER) { |
| _gpsdo_coarse_start(); |
| return; |
| } |
| } else { |
| /* Count invalid measurements and if too many of |
| * them, we go back to hold-over */ |
| if (++g_gpsdo.meas.invalid >= MAX_INVALID) { |
| g_gpsdo.state = STATE_HOLD_OVER; |
| return; |
| } |
| } |
| |
| g_gpsdo.meas.invalid = 0; |
| |
| /* If we reach here, we have a valid fix, valid measurement and |
| * we're not in hold-over or disabled. Feed the correct loop */ |
| if (g_gpsdo.state == STATE_TUNE_COARSE) |
| _gpsdo_coarse_tune(tick_diff); |
| else if (g_gpsdo.state == STATE_TUNE_FINE) |
| _gpsdo_fine_track(tick_diff); |
| } |
| |
| |
| void |
| gpsdo_init(enum gpsdo_vctxo_model vctxo) |
| { |
| /* State */ |
| memset(&g_gpsdo, 0x00, sizeof(g_gpsdo)); |
| |
| /* Default tune to middle range */ |
| g_gpsdo.tune.coarse = 2048; |
| g_gpsdo.tune.fine = 2048; |
| |
| pdm_set(PDM_CLK_HI, true, g_gpsdo.tune.coarse, false); |
| pdm_set(PDM_CLK_LO, true, g_gpsdo.tune.fine, false); |
| |
| /* Initial state and config */ |
| g_gpsdo.state = STATE_HOLD_OVER; |
| g_gpsdo.coarse.vctxo_sensitivity = vctxo_sensitivity[vctxo]; |
| } |