7816 fsm: adjust atr start timeout
The calculation was still expecting timeouts measured in GT instead of
WT, so the actual wait time for empty sim trays (or unresponsive cards)
was 58 seconds instead of ~ 1.5s - a bit longer than necessary.
Total timeout if the atr reception has started is still approximately
45s as per spec (9600 ETU x 32).
Closes: OS#4815
Change-Id: I9f0ae104fac690127ab039ee7d9005e8d3896a1c
diff --git a/ccid_common/iso7816_fsm.c b/ccid_common/iso7816_fsm.c
index 1835368..bf19539 100644
--- a/ccid_common/iso7816_fsm.c
+++ b/ccid_common/iso7816_fsm.c
@@ -250,10 +250,9 @@
card_uart_ctrl(ip->uart, CUART_CTL_RX, true);
/* let's be reasonable here: the 40k cycle delay to ATR start is
- * ~1.4ms @ 2.5Mhz/6720 baud, 1ETU = 372 cycles -> 40k/372=107/12ETU ~ 9 byte
- * default timeout for rx is 9600 ETU, ATR might be missing the TCK
- * so it might time out, so just add this delay */
- card_uart_ctrl(ip->uart, CUART_CTL_RX_TIMER_HINT, 32+9);
+ * ~1.4ms @ 2.5Mhz/6720 baud, 1ETU = 372 cycles -> 40k/372=107/12ETU(GT!) ~ 9 byte
+ * but this is WT not GT, so default 9600 x ETU -> 1 byte wait time is ~1.5s */
+ card_uart_ctrl(ip->uart, CUART_CTL_RX_TIMER_HINT, 1);
osmo_fsm_inst_state_chg(fi, ISO7816_S_WAIT_ATR, 0, 0);
break;
case ISO7816_E_POWER_UP_IND:
@@ -280,6 +279,9 @@
switch (event) {
case ISO7816_E_RX_SINGLE:
+ /* let's expect at most 32 more bytes */
+ card_uart_ctrl(ip->uart, CUART_CTL_RX_TIMER_HINT, 32);
+
osmo_fsm_inst_state_chg(fi, ISO7816_S_IN_ATR, 0, 0);
osmo_fsm_inst_dispatch(ip->atr_fi, event, data);
break;