hw: put board specific pin definition in corresponding file
SIM_PWEN and VCC_FWD are signals specific to the simtrace boards.
the corresponding pins PA5 and PA26 are used for other signal
on the octsim-tester.
Change-Id: I51f37dd112cf681f4b1dbb3d2320ff9a697eaa08
diff --git a/firmware/libboard/simtrace/include/board.h b/firmware/libboard/simtrace/include/board.h
index 0c1e533..7703451 100644
--- a/firmware/libboard/simtrace/include/board.h
+++ b/firmware/libboard/simtrace/include/board.h
@@ -35,7 +35,7 @@
/* Button to force bootloader start (shorted to ground when pressed */
#define PIN_BOOTLOADER_SW {PIO_PA31, PIOA, ID_PIOA, PIO_INPUT, PIO_PULLUP}
/* Enable powering the card using the second 3.3 V output of the LDO (active high) */
-#define SIM_PWEN_PIN {SIM_PWEN, PIOA, ID_PIOA, PIO_OUTPUT_1, PIO_DEFAULT}
+#define SIM_PWEN_PIN {PIO_PA5, PIOA, ID_PIOA, PIO_OUTPUT_1, PIO_DEFAULT}
/* Enable powering the SIM card */
#define PWR_PINS SIM_PWEN_PIN
/* Card presence pin */
@@ -93,9 +93,9 @@
/* Pins used to sniff phone-card communication */
#define PINS_SIM_SNIFF PIN_SIM_IO, PIN_SIM_CLK, PIN_SIM_RST_SNIFF
/* Disable power converter 4.5-6V to 3.3V (active high) */
-#define PIN_SIM_PWEN_SNIFF {SIM_PWEN, PIOA, ID_PIOA, PIO_OUTPUT_0, PIO_DEFAULT}
+#define PIN_SIM_PWEN_SNIFF {PIO_PA5, PIOA, ID_PIOA, PIO_OUTPUT_0, PIO_DEFAULT}
/* Enable power switch to forward VCC_PHONE to VCC_SIM (active high) */
-#define PIN_VCC_FWD_SNIFF {VCC_FWD, PIOA, ID_PIOA, PIO_OUTPUT_1, PIO_DEFAULT}
+#define PIN_VCC_FWD_SNIFF {PIO_PA26, PIOA, ID_PIOA, PIO_OUTPUT_1, PIO_DEFAULT}
/* Use phone VCC to power card */
#define PINS_PWR_SNIFF PIN_SIM_PWEN_SNIFF, PIN_VCC_FWD_SNIFF