enable telnet VTY bind address config for various programs
Following the 'line vty'/'bind A.B.C.D' command added in libosmocore, use the
configured address to set the telnet bind for the VTY line. It is now possible
to publish the VTY on a specific local interface (including 0.0.0.0 aka "any").
Implement in all of:
osmo-gbproxy
osmo-gtphub
osmo-sgsn
osmo-bsc
osmo-bsc_nat
osmo-bsc_mgcp
osmo-nitb
In some of these main programs, move the telnet initialization below the
configuration parsing.
Historically, this was not a good idea for programs using bsc_init.c (aka
bsc_bootstrap_network()), since they expected a gsm_network struct pointer in
((struct telnet_connection*)vty->priv)->priv, so that telnet had to be either
initialized or replaced by a dummy struct. In the meantime, the gsm_network
struct is not actually looked up in a priv pointer but in the static bsc_vty.c
scope (bsc_gsmnet), so this limitation is mere legacy (even though said legacy
is still there in an "#if 0" chunk).
In the other binaries I have briefly looked at the init sequence dependencies
and found no reason to initialize telnet above the config file parsing. In any
case, I have tested every single one of abovementioned binaries to verify that
they still parse the example config successfully and launch, allowing VTY
connections on the configured address(es). I hope this suffices.
In all of the above, log VTY address and port. LOGL_INFO is disabled by default
in some of the logging scopes, and since it is a single log message right at
program launch, I decided for the slightly more aggressive LOGL_NOTICE.
6 files changed