srs{ue,enb}.conf.tmpl: remove restriction of PHY threads for ZMQ
we now support any number of PHY threads also with ZMQ operation
Change-Id: I31abfce742f757179fbfe4099cd0a934db4e63d7
diff --git a/src/osmo_gsm_tester/templates/srsenb.conf.tmpl b/src/osmo_gsm_tester/templates/srsenb.conf.tmpl
index b58db53..81753d6 100644
--- a/src/osmo_gsm_tester/templates/srsenb.conf.tmpl
+++ b/src/osmo_gsm_tester/templates/srsenb.conf.tmpl
@@ -249,7 +249,7 @@
#
# pusch_max_its: Maximum number of turbo decoder iterations (Default 4)
# pusch_8bit_decoder: Use 8-bit for LLR representation and turbo decoder trellis computation (Experimental)
-# nof_phy_threads: Selects the number of PHY threads (maximum 4, minimum 1, default 2)
+# nof_phy_threads: Selects the number of PHY threads (maximum 4, minimum 1, default 3)
# metrics_period_secs: Sets the period at which metrics are requested from the eNB.
# metrics_csv_enable: Write eNB metrics to CSV file.
# metrics_csv_filename: File path to use for CSV metrics.
@@ -265,9 +265,7 @@
[expert]
#pusch_max_its = 8 # These are half iterations
#pusch_8bit_decoder = false
-% if enb.get('rf_dev_type') == 'zmq':
-nof_phy_threads = 1
-% endif
+#nof_phy_threads = 3
#metrics_period_secs = 1
#metrics_csv_enable = false
#metrics_csv_filename = /tmp/enb_metrics.csv
diff --git a/src/osmo_gsm_tester/templates/srsue.conf.tmpl b/src/osmo_gsm_tester/templates/srsue.conf.tmpl
index 3a43f17..05c6c55 100644
--- a/src/osmo_gsm_tester/templates/srsue.conf.tmpl
+++ b/src/osmo_gsm_tester/templates/srsue.conf.tmpl
@@ -293,7 +293,7 @@
# refs: use difference between noise references and noiseless (after filtering)
# empty: use empty subcarriers in the boarder of pss/sss signal
# pdsch_max_its: Maximum number of turbo decoder iterations (Default 4)
-# nof_phy_threads: Selects the number of PHY threads (maximum 4, minimum 1, default 2)
+# nof_phy_threads: Selects the number of PHY threads (maximum 4, minimum 1, default 3)
# equalizer_mode: Selects equalizer mode. Valid modes are: "mmse", "zf" or any
# non-negative real number to indicate a regularized zf coefficient.
# Default is MMSE.
@@ -331,9 +331,7 @@
#snr_ema_coeff = 0.1
#snr_estim_alg = refs
#pdsch_max_its = 8 # These are half iterations
-% if ue.get('rf_dev_type') == 'zmq':
-nof_phy_threads = 1
-% endif
+#nof_phy_threads = 3
#equalizer_mode = mmse
#sfo_ema = 0.1
#sfo_correct_period = 10