OsmoGGSN: more info on non-root operation / tun creation
Add examples for 'ip addr add' and mention correspondence to config file,
add examples for enabling masquerading and IP forwarding,
place the non-root config in its own section and highlight the diffs.
Add tiny hint at systemd-networkd.
Change-Id: I02bd9cfa35c7f2fb338d5d92c2e968fe80574a78
diff --git a/doc/manuals/chapters/configuration.adoc b/doc/manuals/chapters/configuration.adoc
index 9a4c81b..5f61c88 100644
--- a/doc/manuals/chapters/configuration.adoc
+++ b/doc/manuals/chapters/configuration.adoc
@@ -250,7 +250,7 @@
achieved by means such as
* a custom shell script run as root before starting osmo-ggsn (e.g. as init script)
-* systemd .netdev and .network files
+* systemd .netdev and .network files, if your system is using systemd-networkd (see `networkctl status`).
==== Manual TUN device creation / configuration
@@ -266,8 +266,13 @@
Where _username_ and _groupname_ correspond to the User and Group that will have ownership over the
device, i.e. the privileges which you intend to run osmo-ggsn under, and _apn0_ will be the
name of the network device created. After creating the interface, you can configure its addresses
-using standard means like `ip addr add` or your distribution-specific utilities/tools.
+using standard means like `ip addr add` or your distribution-specific utilities/tools
+to match the `ip prefix dynamic` config item, and activate the link, for example:
+----
+# ip addr add 192.168.7.0/24 dev apn0
+# ip link set apn0 up
+----
==== systemd based TUN device creation+configuration
@@ -303,10 +308,16 @@
You may not want this if you have proper end-to-end routing set up, and want to have transparent
inbound IP access to your GPRS-attached devices.
-The pair of the configuration files above allows you to create and configure tun device which can be
-used by OsmoGGSN as follows.
+==== Config Changes
-.Example: using externally configured tun device as non-root
+With the tun device pre-configured in one of the ways outlined above, the main
+changes in your osmo-ggsn.cfg file are:
+
+* remove `ip ifconfig` directive,
+* make sure that `no shutdown` is present in the `apn` section as well as
+ `no shutdown ggsn` in the `ggsn` section.
+
+.Example: using externally configured tun device `apn0` as non-root
----
ggsn ggsn0
gtp state-dir /tmp