icE1usb fw: Fix the E1 shutdown process
So, once BD are submitted to hw, we have to wait for them to get
back, and that's what the SHUTDOWN state is for. Now, this needs
to completete before we can call e1_start() again and so in case
it wasn't done in time, we just busy waited in e1_start().
Problem is that in the absence of a valid signal, the RX side won't
process anything and so we will wait forever.
For the TX side, if we are in remote tick config and we never had
any valid signal, this could also hang.
So we change this. There is actually no need to wait for the shutdown
to complete, we can resume where we left off.
For RX: We use the 'RECOVER' which basically waits for all pending BD
to be done, empty the fifo and auto-restarts. The only "side effect" is
that we'll loose up to 4 multiframe of data at the beginning but the
RX start is async anyway, no guarantee of where we pick up.
For TX: First we empty the FIFO from any data that wasn't already
submitted to the hardware (and is now stale) and we also use the
'RECOVER' state which will wait until the FIFO reaches nominal level
before starting feeding new data. The "side effect" here is we might
TX up to 4 multiframe of old data. Although this is rather unlikely
because the conditions for TX not to have transmitted those before
are unlikely (and hopefully go away completely with OS#5402)
Signed-off-by: Sylvain Munaut <tnt@246tNt.com>
Change-Id: I3f3de5491e0999f89a63f507fafdc4af8c22c905
1 file changed