
/**
 * \file
 *
 * \brief SAM Power manager
 *
 * Copyright (c) 2016-2018 Microchip Technology Inc. and its subsidiaries.
 *
 * \asf_license_start
 *
 * \page License
 *
 * Subject to your compliance with these terms, you may use Microchip
 * software and any derivatives exclusively with Microchip products.
 * It is your responsibility to comply with third party license terms applicable
 * to your use of third party software (including open source software) that
 * may accompany Microchip software.
 *
 * THIS SOFTWARE IS SUPPLIED BY MICROCHIP "AS IS". NO WARRANTIES,
 * WHETHER EXPRESS, IMPLIED OR STATUTORY, APPLY TO THIS SOFTWARE,
 * INCLUDING ANY IMPLIED WARRANTIES OF NON-INFRINGEMENT, MERCHANTABILITY,
 * AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT WILL MICROCHIP BE
 * LIABLE FOR ANY INDIRECT, SPECIAL, PUNITIVE, INCIDENTAL OR CONSEQUENTIAL
 * LOSS, DAMAGE, COST OR EXPENSE OF ANY KIND WHATSOEVER RELATED TO THE
 * SOFTWARE, HOWEVER CAUSED, EVEN IF MICROCHIP HAS BEEN ADVISED OF THE
 * POSSIBILITY OR THE DAMAGES ARE FORESEEABLE.  TO THE FULLEST EXTENT
 * ALLOWED BY LAW, MICROCHIP'S TOTAL LIABILITY ON ALL CLAIMS IN ANY WAY
 * RELATED TO THIS SOFTWARE WILL NOT EXCEED THE AMOUNT OF FEES, IF ANY,
 * THAT YOU HAVE PAID DIRECTLY TO MICROCHIP FOR THIS SOFTWARE.
 *
 * \asf_license_stop
 *
 */

#include <hpl_sleep.h>
#include <hpl_init.h>

/**
 * \brief Set the sleep mode for the device
 */
int32_t _set_sleep_mode(const uint8_t mode)
{
	uint8_t delay = 10;

	switch (mode) {
	case 2:
	case 4:
	case 5:
	case 6:
	case 7:
		hri_pm_write_SLEEPCFG_reg(PM, mode);
		/* A small latency happens between the store instruction and actual
		 * writing of the SLEEPCFG register due to bridges. Software has to make
		 * sure the SLEEPCFG register reads the wanted value before issuing WFI
		 * instruction.
		 */
		do {
			if (hri_pm_read_SLEEPCFG_reg(PM) == mode) {
				break;
			}
		} while (--delay);
		break;
	default:
		return ERR_INVALID_ARG;
	}

	return ERR_NONE;
}