diff --git a/sysmoOCTSIM/hpl/port/hpl_gpio_base.h b/sysmoOCTSIM/hpl/port/hpl_gpio_base.h
new file mode 100644
index 0000000..f32c40f
--- /dev/null
+++ b/sysmoOCTSIM/hpl/port/hpl_gpio_base.h
@@ -0,0 +1,172 @@
+
+/**
+ * \file
+ *
+ * \brief SAM PORT.
+ *
+ * Copyright (c) 2014-2018 Microchip Technology Inc. and its subsidiaries.
+ *
+ * \asf_license_start
+ *
+ * \page License
+ *
+ * Subject to your compliance with these terms, you may use Microchip
+ * software and any derivatives exclusively with Microchip products.
+ * It is your responsibility to comply with third party license terms applicable
+ * to your use of third party software (including open source software) that
+ * may accompany Microchip software.
+ *
+ * THIS SOFTWARE IS SUPPLIED BY MICROCHIP "AS IS". NO WARRANTIES,
+ * WHETHER EXPRESS, IMPLIED OR STATUTORY, APPLY TO THIS SOFTWARE,
+ * INCLUDING ANY IMPLIED WARRANTIES OF NON-INFRINGEMENT, MERCHANTABILITY,
+ * AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT WILL MICROCHIP BE
+ * LIABLE FOR ANY INDIRECT, SPECIAL, PUNITIVE, INCIDENTAL OR CONSEQUENTIAL
+ * LOSS, DAMAGE, COST OR EXPENSE OF ANY KIND WHATSOEVER RELATED TO THE
+ * SOFTWARE, HOWEVER CAUSED, EVEN IF MICROCHIP HAS BEEN ADVISED OF THE
+ * POSSIBILITY OR THE DAMAGES ARE FORESEEABLE.  TO THE FULLEST EXTENT
+ * ALLOWED BY LAW, MICROCHIP'S TOTAL LIABILITY ON ALL CLAIMS IN ANY WAY
+ * RELATED TO THIS SOFTWARE WILL NOT EXCEED THE AMOUNT OF FEES, IF ANY,
+ * THAT YOU HAVE PAID DIRECTLY TO MICROCHIP FOR THIS SOFTWARE.
+ *
+ * \asf_license_stop
+ *
+ */
+#include <compiler.h>
+#include <hpl_gpio.h>
+#include <utils_assert.h>
+#include <hpl_port_config.h>
+
+/**
+ * \brief Set direction on port with mask
+ */
+static inline void _gpio_set_direction(const enum gpio_port port, const uint32_t mask,
+                                       const enum gpio_direction direction)
+{
+	switch (direction) {
+	case GPIO_DIRECTION_OFF:
+		hri_port_clear_DIR_reg(PORT, port, mask);
+		hri_port_write_WRCONFIG_reg(PORT, port, PORT_WRCONFIG_WRPINCFG | (mask & 0xffff));
+		hri_port_write_WRCONFIG_reg(
+		    PORT, port, PORT_WRCONFIG_HWSEL | PORT_WRCONFIG_WRPINCFG | ((mask & 0xffff0000) >> 16));
+		break;
+
+	case GPIO_DIRECTION_IN:
+		hri_port_clear_DIR_reg(PORT, port, mask);
+		hri_port_write_WRCONFIG_reg(PORT, port, PORT_WRCONFIG_WRPINCFG | PORT_WRCONFIG_INEN | (mask & 0xffff));
+		hri_port_write_WRCONFIG_reg(PORT,
+		                            port,
+		                            PORT_WRCONFIG_HWSEL | PORT_WRCONFIG_WRPINCFG | PORT_WRCONFIG_INEN
+		                                | ((mask & 0xffff0000) >> 16));
+		break;
+
+	case GPIO_DIRECTION_OUT:
+		hri_port_set_DIR_reg(PORT, port, mask);
+		hri_port_write_WRCONFIG_reg(PORT, port, PORT_WRCONFIG_WRPINCFG | (mask & 0xffff));
+		hri_port_write_WRCONFIG_reg(
+		    PORT, port, PORT_WRCONFIG_HWSEL | PORT_WRCONFIG_WRPINCFG | ((mask & 0xffff0000) >> 16));
+		break;
+
+	default:
+		ASSERT(false);
+	}
+}
+
+/**
+ * \brief Set output level on port with mask
+ */
+static inline void _gpio_set_level(const enum gpio_port port, const uint32_t mask, const bool level)
+{
+	if (level) {
+		hri_port_set_OUT_reg(PORT, port, mask);
+	} else {
+		hri_port_clear_OUT_reg(PORT, port, mask);
+	}
+}
+
+/**
+ * \brief Change output level to the opposite with mask
+ */
+static inline void _gpio_toggle_level(const enum gpio_port port, const uint32_t mask)
+{
+	hri_port_toggle_OUT_reg(PORT, port, mask);
+}
+
+/**
+ * \brief Get input levels on all port pins
+ */
+static inline uint32_t _gpio_get_level(const enum gpio_port port)
+{
+	uint32_t tmp;
+
+	CRITICAL_SECTION_ENTER();
+
+	uint32_t dir_tmp = hri_port_read_DIR_reg(PORT, port);
+
+	tmp = hri_port_read_IN_reg(PORT, port) & ~dir_tmp;
+	tmp |= hri_port_read_OUT_reg(PORT, port) & dir_tmp;
+
+	CRITICAL_SECTION_LEAVE();
+
+	return tmp;
+}
+
+/**
+ * \brief Set pin pull mode
+ */
+static inline void _gpio_set_pin_pull_mode(const enum gpio_port port, const uint8_t pin,
+                                           const enum gpio_pull_mode pull_mode)
+{
+	switch (pull_mode) {
+	case GPIO_PULL_OFF:
+		hri_port_clear_PINCFG_PULLEN_bit(PORT, port, pin);
+		break;
+
+	case GPIO_PULL_UP:
+		hri_port_clear_DIR_reg(PORT, port, 1U << pin);
+		hri_port_set_PINCFG_PULLEN_bit(PORT, port, pin);
+		hri_port_set_OUT_reg(PORT, port, 1U << pin);
+		break;
+
+	case GPIO_PULL_DOWN:
+		hri_port_clear_DIR_reg(PORT, port, 1U << pin);
+		hri_port_set_PINCFG_PULLEN_bit(PORT, port, pin);
+		hri_port_clear_OUT_reg(PORT, port, 1U << pin);
+		break;
+
+	default:
+		ASSERT(false);
+		break;
+	}
+}
+
+/**
+ * \brief Set gpio pin function
+ */
+static inline void _gpio_set_pin_function(const uint32_t gpio, const uint32_t function)
+{
+	uint8_t port = GPIO_PORT(gpio);
+	uint8_t pin  = GPIO_PIN(gpio);
+
+	if (function == GPIO_PIN_FUNCTION_OFF) {
+		hri_port_write_PINCFG_PMUXEN_bit(PORT, port, pin, false);
+
+	} else {
+		hri_port_write_PINCFG_PMUXEN_bit(PORT, port, pin, true);
+
+		if (pin & 1) {
+			// Odd numbered pin
+			hri_port_write_PMUX_PMUXO_bf(PORT, port, pin >> 1, function & 0xffff);
+		} else {
+			// Even numbered pin
+			hri_port_write_PMUX_PMUXE_bf(PORT, port, pin >> 1, function & 0xffff);
+		}
+	}
+}
+
+static inline void _port_event_init()
+{
+	hri_port_set_EVCTRL_reg(PORT, 0, CONF_PORTA_EVCTRL);
+	hri_port_set_EVCTRL_reg(PORT, 1, CONF_PORTB_EVCTRL);
+	hri_port_set_EVCTRL_reg(PORT, 2, CONF_PORTC_EVCTRL);
+	hri_port_set_EVCTRL_reg(PORT, 3, CONF_PORTD_EVCTRL);
+}